keywords: ip pbx voip gateway gsm gateway

×

Notice

The forum is in read only mode.
× Questions about A400/800/1200 Analog Interface Card

Fax Detection problems

14 years 3 months ago #4753 by ali_com_01
Hi
I tested again, this problem is only for FXS extensions not sip extensions!!

Thanks for any help or gidancce
14 years 3 months ago #4754 by aerodesliza
enable disconnted supervision
14 years 3 months ago #4755 by ali_com_01

Original posted by aerodesliza at 2010-2-14 23:27


enable disconnted supervision

Hi
thanks for your reply
But I do not know how enable this option.

Thanks
14 years 3 months ago #4756 by aerodesliza
You have to added following two lines to zapata.conf:callprogress=yesbusydetect=yes

regard
14 years 3 months ago #4758 by ali_com_01
Hi
Unfortunately with adding that lines, I still have same problem!!
I put my chan_dahdi.config:
[trunkgroups]

[channels]
context=from-zaptel
signalling=fxs_ks
rxwink=300              ; Atlas seems to use long (250ms) winks
usecallerid=yes
hidecallerid=no
callwaiting=yes
usecallingpres=yes
callwaitingcallerid=yes
threewaycalling=yes
transfer=yes
canpark=yes
cancallforward=yes
callreturn=yes
echocancel=yes
echocancelwhenbridged=no
faxdetect=incoming
;echotraining=800
rxgain=1
txgain=1
callgroup=1
pickupgroup=1
;cidstart=polarity
;cidsignalling=dtmf
callprogress=yes

;Uncomment these lines if you have problems with the disconection of your analog lines
busydetect=yes
busycount=3


immediate=yes

#include dahdi-channels.conf
#include chan_dahdi_additional.conf
Of course there are another configuration files, dahdi-channels.conf and chan_dahdi_additional.conf, that I put them too:
dahdi-channels.conf:
; Span 1: WCTDM/4 "Wildcard TDM400P REV E/F Board 5" (MASTER)
;;; line="1 WCTDM/4/0 FXSKS"
signalling=fxs_ks
callerid=asreceived
group=0
context=from-zaptel
channel => 1

group=
context=default

;;; line="2 WCTDM/4/1 FXOKS"
signalling=fxo_ks
callerid="Channel 2" <4002>
mailbox=4002
group=5
context=from-internal
channel => 2
callerid=
mailbox=
group=
context=default
chan_dahdi_additional.conf:
;;;;;;[1003]
signalling=fxo_ks
pickupgroup=
mailbox=1003@device
immediate=no
echotraining=800
echocancelwhenbridged=no
echocancel=yes
context=from-internal
callprogress=no
callgroup=
callerid=device <1003>
busydetect=no
busycount=7
accountcode=
channel=>2
Thanks for more help

i] Last edited by ali_com_01 at 2010-2-15 22:08 [/i
14 years 3 months ago #4759 by aerodesliza
Did you do a amportal stop/start? Try disabling the fax detection feature and check if the problem persist.
Let me know.
Time to create page: 0.034 seconds
Powered by Kunena Forum